Air Defense Artillery Regulation Double side Guidon
Army Guidons are done IAW AR 840-10. Manufactured with U.S. made 200 denier nylon. All stitching is done with marine grade thread and all stress point are reinforced. Letters and numbers are stitched and appliqued never screen printed. All colors and designs are taken from from the Army Regulation and drawings or cartoon from TIOH. The Colors of the new guidon compared to the current one might vary due to the age of fabric and exposure to the elements.
Crossed cannons (field guns) for Artillery has been in continuous use since 1834, when they were played on regimental colors, knapsacks, and as part of the cap insignia for Artillery officers.
An Act of Congress, 2 February 1901, divided the Artillery arm into Coast and Field Artillery and the insignia was modified by the addition of a plain scarlet oval at the intersection of the crossed cannons. On 17 July 1902, the Coast Artillery insignia was created by the addition of a gold projectile on the red oval. Concurrently, the Field Artillery insignia was created by the addition of a gold wheel on the red oval; this insignia was replaced by two crossed field guns (a lighter form of cannon), the design of which was approved on 4 April 1907.
The Army Organization Act of 1950 consolidated Coast and Field Artillery to form the Artillery Arm, and the crossed field guns was redesignated as the Artillery branch insignia on 19 December 1950. This insignia was superseded on 2 January 1957 by a new insignia consisting of crossed field guns surmounted by a missile, all gold.
On 20 June 1968, Air Defense Artillery was established as a basic branch of the Army and on 1 December 1968, the ADA branch was authorized to retain the former Artillery insignia, crossed field guns with missile.
AR 840-10 describes a guidon as the following.
6–4. Description
A guidon is a swallow-tailed unit marker, 20-inch hoist by a 27-inch fly, the swallow-tail end forked 10 inches. Fringe is not used on guidons. Guidons are made of bunting cloth or nylon, unless otherwise specified. Design elements will appear on the opposite side as if printed through the material. Letters and numerals will read from left to right on each side (will appear proper on each side) of the guidon (see fig 6–1). The letters and numbers on guidons are 3 1/2 inches high, unless otherwise indicated. When a SSI is authorized for use on the guidon, the design will appear proper on both sides.
Made with pride in West Texas, USA by Artisans with years of experience in tailoring, embroidery and design.
Contracting Information
DUNS- 828301411
CAGE- 56V42
SAME- VR8RC912KSV8
Picture for demonstration purposes only.
